Polypropylene fiber POLIARM

Polypropylene fiber POLIARM

375 руб.

№ 1545771, posted 1 year ago

Параметры

View ad: The product from the manufacturer

Описание

Rigid polymer fiber is used instead of steel fibers for reinforcement of cement mortars. Compared with steel fibers, it is easier to spread and mixed in cement mixing, without bringing damage to the concrete mixing and feed equipment. As raw material for the production of rigid polymer fibre is used polypropylene PRIMARY. This type of fiber has a high tensile strength. Given these features, rigid polymer fiber can be widely used instead of steel fibers for reinforcement of cement mortars, giving the resulting concrete increased tremendoustomato.
Features
This type of fiber is an alternative to using steel fiber designed for heavy concretes and screeds operated in harsh environments.
The scope of
Reinforcement of heavy concrete, increasing the strength characteristics of industrial ties, the strengthening of the structural characteristics of the foundations, bridge beams etc.
The effect of
The use of rigid polymer fiber can significantly reduce costs in comparison with steel fibers (specific gravity of steel fiber is about 9 times more, respectively, the number of individual fibres is less). Polymer fiber has no negative influence on the faucets and distributors of concrete and does not corrode.
Usage instructions
Dosage
The volume fraction of the reinforcing fiber in heavy concrete shall be not less than 0.3 %, which corresponds to 2.7 kg of tough polymeric fibers.
Depending on the type of concrete and the conditions of use recommended amount of hard polypropylene fibers varies within the following limits:
-industrial floors, screed: 1.5 m-4.7 kg/m3 (corresponds to 25-40 kg of steel fibers)
-structural elements of residential buildings: 2.9 to 5.8 kg/m3 (corresponding to 25-50 kg of steel fibers)
-structural elements of tunnels, roads, mines: 5,8-11,6 kg/m3 (corresponds to 50-100 kg of steel fibers)
-hydraulic structures (dams, bridges), Bank vault: 11,6-14,0 kg/m3 (corresponds to 100-120 kg of steel fibers).
Fiber length: to give the heavy concrete of the required resistance to cracking are used, the fiber length less than 40 mm.
Mix
Fiber is added to the mixer at the initial stage, together with stone and sand, after stirring for 2 minutes, the fiber is evenly distributed, then add cement and water. You can also use various additives and plasticizers, but in this case it is not required recommendation, as the use of steel fibers. Special conditions for the production of concrete using stiff polymer fibers is not required, the technology of preparation of concrete modificeres.